CCL: The use of NMR spectra computations for verification of computational
method
- From: Susi Lehtola <susi.lehtola-*-alumni.helsinki.fi>
- Subject: CCL: The use of NMR spectra computations for verification
of computational method
- Date: Tue, 22 Sep 2015 15:25:36 -0700
Sent to CCL by: Susi Lehtola [susi.lehtola()alumni.helsinki.fi]
Dear Grigoriy,
if you are asking something, please formulate your message using
paragraphs. A wall of text is hard to read, and most people will just
skip over it.
On 09/21/2015 10:19 AM, Grigoriy Zhurko reg_zhurko^chemcraftprog.com wrote:
The PMR spectrum with B3LYP correlates with the experimental one with
R=0.997, and with PBE ? R=0.995. These values do not differ very
much. But the coefficient B in the equation Y=A+B*X (for the linear
approximation of experiment vs theory graph) is 1.02 for B3LYP, and
1.14 for PBE. So, with PBE it is far less from 1.
So here you are talking about how well the values reproduced by theory
agree with experiment, allowing for systematic error in the theory that
follows a linear model.
Indeed, the R values are close to one, which indicates the linear model
is good. The different B (and A?) values just indicate that the
functionals produce different values for the shielding constants, but as
both R values are good, you should be able to easily convert a PBE value
to B3LYP or vice versa.
Does that mean that PBE is much less appropriate method for this
task?
I'm not an expert on NMR. However, judging from your data, I would say
that the answer is no. Naturally if your theory reproduced
experiment exactly you'd have A=0 and B=1. Here, both functionals give
somewhat incorrect values, since A!=0 and B!=1. However, the error in
the values seems to be systematical, which you can correct for by
solving x from y.
I suppose, that the systematic error of absolute values of the NMR
chemical shifts is caused by unclear physical meaning of these
chemical shifts and shieldings (maybe the solvent gives some
additional shielding in experiment).
Naturally, effects that aren't included in your modeling will affect the
goodness of your model. In general, you might see this as unexpected
values of A and B, or by a breakdown of your model (small R).
So, my question is, whether the B coefficient in correlation must be
always equal 1.
No.
If yes, then instead of correlation coefficients R I should use
another criteria of computation accuracy?
If B were always equal to 1 you wouldn't really need R at all. R is a
measure of how well y = a + bx fits your data.
the RMS of MAE difference between the computed and experimental
chemical shifts, if the shielding of the standard (TMS) simply
fitted for best agreement (not computed quantum-chemically). Is that
correct?
What?
In my case, these MAE difference must be much bigger for PBE
functional, than for the B3LYP functional.
If you took the uncorrected values, sure. But if you applied the
correction for the systematical error, both should give similarly
accurate results.
--
-----------------------------------------------------------------------
Mr. Susi Lehtola, PhD Chemist Postdoctoral Fellow
susi.lehtola : alumni.helsinki.fi Lawrence Berkeley National Laboratory
http://www.helsinki.fi/~jzlehtol USA
-----------------------------------------------------------------------