Back to Alphabetical List

 
 OFFSET 
 
 

Permits to specify the offset of the right-most (upper right most in 
2D) point of the data set. The value for offset are changed by 
EXTRACT
 

see also : calib size SPECW

 
 OFFSET3D 
 
 

offset3d dx dy dz
This context holds the shift by which the (0,0,0) point will be 
shifted from the lower left corner of the DISP3D window during a 3D 
display with the DISP3D/REF3D set of commands. A value of 0 
corresponds to the lower left corner; a value of 1 to the upper 
right corner; a value of 0.5 corresponds to the center of the 
window.

see also : CHECK3D DISP3D PLOT3D

 
 ONE 
 
 

Put the value one (1.0) in the current buffer

see also : MINUS PLUS ZERO

 
 OPEN 
 
 

OPEN file_name
Opens the file called file_name for reading or writing. Writing is 
performed with the FPRINT command. Reading is done through the 
<file_name syntax.
e.g.   read <file_name
	read the file which name is found as the next line of the file 
file_name
set line = <file_name
	set the variable line to the contents of the next line of the 
file file_name
OPENing an already OPENed file will rewind the file to the 
beginning.

see also : CLOSE DBOPEN FPRINT

 
 ORDER 
 
 

ORDER n
This context determines the order for all linear prediction 
operations. Should be an integer, typically one third of data size 
for spectral analysis, smaller values for simple operations such as 
compacting. You should set it before starting any linear prediction 
calculation.

see also : BURG DT->AR DT->SVD

 
 OUTPUT 
 
 

 1 create numeric output of the data for each Maximum Entropy 
iteration
Mostly used for debugging purpose.
 

see also : MAXENT

 
 OVERIT 
 
 

Controls Maximum Entropy stop points. Overiteration is on then 
CHI2 = 1.0 is no more the stopping criterion; and only the iteration
counter is considered.
 0 inhibits over-iteration, 1 permits it.
 

see also : ITER MAXENT MAXENTCONT